Just a question. What are you using for Naruto's clones (don't know if you stated this or not).

Seeing as this is over Ike, I'm guessing it's the Aether Sword thing. Just an assumption.

I'm quite positive you can't get anything lower than 1 in PSA (because of the godforsaken Hex values), but I know you can get lower in BBox (or at least I remember getting something lower in BBox).

Then there's always the frame thing you wanted to do. Then there's a multitude of ideas that we haven't even thought up of. Either way, I shall be interested to see how this specific Special develops.

Using PSA or BBox?

Most likely PSA. But never a bad thing to ask, is it?

It seems like one hit does 1 damage, why not just decrease it to something like 0.25 per hit or something lower?

Just an alternative. Don't know if you've looked into it or not.

I saw that if you go on too long that you'll get your shield crush with 15% damage, I was wondering if there was any drawback for hitting an enemy for a long time.

Regardless, it's still in Pre-Alpha, so there's no doubt that it'll be working as intended when it's finished.

Good Job

I've had my eye on this topic for a while. Just didn't say anything because... honestly, I don't know.

I like the concept of the Neutral B. But, what would happen if you left the Neutral B running when someone was getting hit by it?

So I tried setting up RiiFs some time back, but it didn't work (can't remember what the problem was). Out of the blue, I got a sudden urge to try and set it up now. So, I followed the second set of instructions here:

http://forums.kc-mm.com/index.php?topic=42927.0

But to no avail. Whenever Riivolution would load up the GUI would be there, but the only options I would have would be to Uninstall/Install (Riivolution), Load, or Exit. I didn't have any ability to change the modset I was using or anything.

I double checked my IP address to make sure it was correct (it was). I also checked to make sure that all the files were in the right place (they were). The only problem that I can see was that instead of using the xml that I've been usually using, I used the Project M xml. But if anything, that should work.

Any ideas on what could be wrong?

well snake and gannon does work on rii i was using a micro sd for my brawl hacks and they did not work but  when i got a normal sd card they worked

Just looked back at this.

Any updates on these two?

^this and also Mario rel

^this and also Link rel

Someone had to say it

if your trying to open a psa that was saved in smash attacks the only 67 will work

That's probably it

Thanks

You don't have to say that again.

inb4 you say it again

Nope, 0.67 seems to be fine.

Most current one, v0.67b

Hey guys, not sure if this really belongs here, but it's here.

Anyways, to the reason why this topic is even here...

I opened up a fitlink.pac and scrolled down to the effects section. I tried to preview one of the models, but it said that BBox had to close. I tried this with different pac files and different models. Same result.

Is something wrong with my BBox that I can fix? Or should I just redownload and save myself the trouble?

Alrighty then, thanks.