Guide to Stage Builder Block Based Stages

[ForOhFor Error]

I may be making a guide on editing the stage builder parts themselves eventually.

[ShadowSnake]

very useful guide.  :o i might retire from vertexes for awhile and make some stages. sounds fun and i have some good ideas.

[Segab]

Bumping this because it's one of the only good stage tutorials I've found.

Also, you give a few models with it, but I can never get the 2D model to work..
Doesn't really matter, I'm using the cube model and make it less wide so that it looks flat.

[ForOhFor Error]

I included a 'bad' 2D model. It's very confusing to use, and has too many bones.
If anyone finds a better one, let me know.

[Gamma Ridley]

Really? The 2D model seems to work fine for me. /:

Unless you recently changed the model for something else and I'm unaware of it.

[ForOhFor Error]

No, I haven't. It's just, well, harder to get to position correctly.

[Segab]

-fixed, removed-

Also, do you know where I could get a skybox model? Every time I try to extract one from a stage, it's not separated from the stage itself.

[ShinySpiritSeer]

I have a question
When I added another modeldata, the stage freezes
is there too many modeldata's?

[ForOhFor Error]

A stage only works with a fixed amount of modeldata brres files. If you add or remove any, the stage won't work.

[Mewtwo2000]

If you add one, it doesn't stop working. Only the removal causes freezing.

I make my stages work over many slots by including lots of empty modeldatas. If adding them was bad, they wouldn't work over final destination.

[ShinySpiritSeer]

ok, well ill try that.

[SemiPsycho]

May you post a demonstration of your stage?

[Mudkip97]

For some reason when I downloaded this it did not come with any block models?

[SUPAHSAWNIK99]

Ok, so I made my stage with models, textures, collisions, and all that jazz, following your instructions, and the result of me finishing and trying to save the stage, and I get an error that says, "Object reference not set to an instance of an object." Can anybody fill me in on what the heck I just did wrong?! I can't close the program because IT WON'T SAVE!!!!!

Post Merge: October 26, 2014, 04:14:59 AM
Never mind..... I just lost all of the work I had........